Using a Stripe reader

Stripe make a terminal which wirelessly connects to your device and which will allow you to accept credit/debit card payments via either tapping or inserting them in the reader. The device is not inexpensive so it may only be appropriate for larger organisations with a high level of Stripe transactions. 

The reader we have configured and which connects wirelessly to  your computer device is the Stripe S700. 

There is a $50 plus GST annual charge for connecting a Stripe card reader attached to your account.

HOW TO SET UP YOUR STRIPE s700 CARD READER TO USE WITH MEMBER WIZARD

1. Your Stripe card reader connects directly to Stripe (not your computer) over the internet so you must have an internet connection to use it.

2. Connect the reader to power by plugging in the USB C cable into the port on the left hand side of the reader and plugging it into a power point. A full battery will last about 15 hours on average. The LED indicator will change to yellow if the battery is low and red if it is critically low. It will flash blue when charging and be green when fully charged with power connected.

3. After the reader is fully charged, hold down the power button on the right hand side until the screen turns on. If the device goes to sleep this button will also wake it.

4. To turn the reader off hold down the power button till the power off option appears on the screen and then select it.

5. Its suggested you leave the device plugged in and on charge when not in use so it can stay fully charged and get software updates.

Pairing with your Stripe Account

Connect to wifi

1. Open Settings by swipe right from the left edge of the reader screen to show the Settings button.

2. Tap the button and enter the admin PIN code of 07139.

3. From this menu you can connect to your Wifi or generate a pairing code to register your device. You will need your wifi device’s wifi password to complete the wifi connection to the internet.

Pairing your device with your Stripe account

1. Log into your Stripe account and in the search bar at the top of the dashboard search for Terminal.

2. Select Terminal/Readers

3. Click Register Reader

4. Enter the serial number of your device in the field which appears on the left.

5. Click +Add New and register a location for the reader.

If you have any problems please email developer@memberwizard.com.au and someone will be in touch to step you through any issues.